Zenoah G455AVS Guía para resolver problemas Pagina 1

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. WA

1. H and L needles are restricted within the numberof turn as shown below, because this engineconforms to 1995 California regulations for utilityand l

Chain brake This machine is equipped with an automatic braketo stop saw chain rotation upon occurrence ofkickback while in saw cutting operation. The

NOTE: • Before proceeding to your job, read “ForSafe Operation” section. It isrecommended to first practice sawingeasy logs. This also helps you getac

1. Decide the felling direction considering thewind, Iean of the tree, location of heavybranches, ease of job after felling, andother factors . 2. Whi

6. MaintenaceBefore cleaning, inspecting or repairingyour unit, make sure that engine hasstopped and is cool. Disconnect the sparkplug to prevent acci

B. Periodical service points 1. Cylinder fins Dust clogging between the cylinder fins will causeoverheating of the engine. Periodically check andclean

A. Saw Chain It is very important for smooth and safeoperation to keep the cutters always sharp.Your cutters need to be sharpened when: • Sawdust beco

After every cutter has been set, check the depthgauge and file it to the proper level as illustrated. Be sure to round off the front edge toreduce the

B. Guide Bar • Reverse the bar occasionally to prevent partialwear. • The bar rail should always be a square. Checkfor wear of the bar rail. Apply a r

Check fuel for water or incorrect mixture. Replace with proper fuel.Check engine for flooding. Remove and dry the spark plug.Repeat pulling starter wi

9. SpecificationsModel G455AVS Power unit: Dis placement cc (cu. in.) 45.0 (2. 75)Fuel Mixture (Gasoline 32: Two-cycle oil 1) Fuel tank capacity cc

10. Parts List NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/orreplacement. 2. KOMATSU ZENOAH does not warr

10. Parts List : G455AVS20

21

Key# Part Number Description Q'ty NOTE1 2670-12112 CYLINDER 12 2810-14110 INLET PIPE 13 2817-14121 GASKET 1 ✻14 2670-14130 SCREW 25 2880-14150 GU

Key# Part Number Description Q'ty NOTE107 2880-35211 DAMPER 2108 3350-35170 BOLT 2109 2880-35250 CAP 2110 2810-31115 CYLINDER COVER 1111 2670-143

10. Parts List : G455AVS24

25✻1 Special tools (Opt. Part)Key# Part Number Description Q'ty NOTE1 2812-81000CARBURETOR ASS’Y–2 3306-81380 SCREEN 13 2810-81120 COVER 14 3310-

THE CALIFORNIA AIR RESOURCES BOARD AND KOMATSU ZENOAH Co. ARE PLEASED TOEXPLAIN THE EMISSION CONTROL SYSTEM WARRANTY ON YOUR 1995 AND LATER LAWN ANDGA

RedMax CHAIN SAWMODELS G455AVS1-YEAR LIMITED WARRANTYKOMATSU ZENOAH AMERICA INC. 1505 Pavilion Place Suite A Norcross, Georgia 30093 EMISSION-RELATED

Thank you for choosing our RedMax® chain saw. This manual will provide you with full understanding of the necessaryinstructions for assembly, operatio

KOMATSU ZENOAH AMERICA INC.1505 Pavilion Place Suite ANorcross, Georgia 30093Printed in Japan

1. For Safe Operation21. Never operate a chain saw when you arefatigued, ill, or upset, or under theinfluence of medication that may makeyou drowsy, o

316. Operate the chain saw only in wellventilated areas. Never start or run theengine inside a closed room or building.Exhaust fumes contain dangerous

The saw chain has very sharp edges. Usethick protective gloves for safety.1. Loosen the nuts and remove the chain cover. 2. Install the attached spike

FUEL The RedMax engines are lubricated by oilspecially formulated for air-cooled 2-cyclegasoline engine use. If RedMax oil is notavailable, use an a

Starting engine 1. Fill fuel and chain oil tanks respectively, andtighten the caps securely. 2. Tilt the switch lever upward. 3. While holding the thr

5. While holding the saw unit securely on theground, pull the starter rope vigorously. Do not start the engine while hanging thechain saw with a hand.